3pc Replacement Trimmer Line and Spool Cap
WG122, 150, 151, 152, 153, 154, 155, 156, 157, 160, 162, 163, 165, 166, 167, 170, 175, 180 Series.
Remove the spool cap and empty spool from the grass trimmer. Insert the end of the line through the eyelet on the trimmer. Align the spool ratchet-pattern side of the spool onto the trimmer and ensure it is seated flat. Place the spool cap back into place.
Take approximately 10 feet (3m) of line. Insert 5/8 inch (15mm) of line into the Spool holes and wind line in the direction of the arrows on the top of the Spool. Leave approximately 4 inches (100mm) of line unwound and place into the cleat/notch. Ensure that the line is neatly coiled, side-by-side, on the Spool. Failure to do so will impair the efficiency of the automatic line feed.
IMPORTANT INFORMATION
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including lead, phthalate or bisphenol A which are known to the State of California to cause cancer, birth defects or other reproductive harm. Wash your hands after use. For more information go to www.P65Warnings.ca.gov.
PROPOSITION 65 DE LA CALIFORNIE AVERTISSEMENT:
Ce produit peut vous exposer à des produits chimiques, incluant au plomb, au phtalate ou au bisphénol A, qui sont reconnus dans l'Ètait de Californie comme pouvant causer un cancer, des anomalies congénitales ou d'autres dommages à l'appareil reproducteur. Assures-vous de bien vous laver les mains après usage. Pour en savoir plus, veuillez consulter le site www.P65Warnings.ca.gov.