Flexible Shaft for Cordless Screwdriver (WA1061)
The Flexible Shaft for Cordless Screwdrivers is an accessory designed to work with Worx Cordless Screwdrivers to give you the ultimate access to difficult-to-reach places or to get around immovable obstacles. Whether a job is at an awkward angle, or in a space too small to reach with the whole screwdriver, this accessory puts it within your reach. Remove the bit from your cordless screwdriver and install the 1/4” hex end. Add any 1/4” hex screwdriver bit into the other end. Bend the Flexible Shaft to reach where you need to work and operate your cordless screwdriver as normal.
While the Flexible Shaft will fit in Worx drills, it is designed for Cordless Screwdrivers like the SD Semiautomatic Driver (WX254L), the XTD Xtended Reach Driver (WX252L) and the SD Driver with Screw Holder (WX255L). The Flexible Shaft should not be used on any power tool in excess of 400 rpms or 3Nm (approx. 27 in-lbs) of torque.
The shank is a 1/4” hex shank. While this fits a wide variety of drills and drivers, the Flexible Shaft is designed for Cordless Screwdrivers. It should not be used on any power tool in excess of 400 RPMs or 3Nm (approx. 27 in-lbs) of torque.
Always wear the proper safety gear and maintain a clean, safe workspace. For more information, please check out the owner’s manual.
If you decide the Worx Flexible Shaft for Cordless Screwdrivers isn’t right for you, we offer a 30-day Money Back Guarantee from date of receipt (less shipping and handling). View more information here.
Parts subject to normal wear and tear are not covered by the tool’s warranty. View more information on our warranty here.