Wood Slice Bottle Opener

close up of bear face on wooden wall mount bottle openerclose up of bear face on wooden wall mount bottle opener

Step-by-Step Instructions


1. Place the adhesive stencil on the wood slice and press down the edges firmly. Cover any exposed areas to protect the surface before airbrushing.

bear bottle open design sitting on wood piece next to worx air brush

2. Load the paint reservoir of the airbrush approximately ⅓ full with black airbrush paint and begin painting in a consistent swirling motion about four to six inches away from the stencil. Once complete, set to dry before removing the stencil.

3. Use the rotary tool to give the bottle opener a distressed vintage look by sanding down some areas with the wire brush accessory. When complete, wipe clean with a damp rag.

4. Measure and mark the bottle opener to the wood slice and predrill holes for screws. Screw the bottle opener in place.

drill hole into bottom of the wood with painted words on it

5. Add hardware to the back of the wood slice to hang and enjoy!